Here you can see we have started disassembling your engine. Upon removing the head we found surface rust on the cylinder walls and if you look to the picture to the far right it shows some build up on the cylinder wall where the piston was actually stuck to the wall. What we will do is hone the cylinder walls in hopes that this will take care of the problem but if the damage goes to deep we will them have to bore the cylinders and install over-sized rings in the pistons.
In the pictures above you will see that the cylinders have been honed and that the crankshaft has been machined. Also we have received the parts needed to start assembling the engine.
We are getting close to a complete engine. The block has been put back together and we have began detailing and painting the engine.