Woodies Restorations -

Toll Free Phone Number 866-921-2628

270-343-2628

Paul@woodiesrestorations.com

1938 CC 15.5' Runabout

Here is a picture of our fuel pick up. It consists of the tube anti syphon and shut off valve. We can cut the tubes down to the required size for the tank.

Here is the drawing you sent of your fuel tank. We will need to know where your tank straps are located to determine placement for your fuel pick up tube. Your tank vents through the tank cap. With that being said if you do not have straps for your tank you can measure the spacing and position of the tank supports. If you do not have straps we can also reproduce those for you.

Here is a picture of a tank we reproduced for a 1937 17' Runabout. The three tank fittings (from left to right) are for Vent, Fill and Fuel Pickup. Because we haven't made a copy of a tank like yours we don't know where the fuel pickup needs to be. You wont need a vent fitting as your tank vents through the cap. This will give you an idea of what your tank will look like when complete.

#U155 Starter Switch

1 5" Lifting Eye

1 Wheel 17" Black

1 Black Horn Button

1 Fuel Tank Cap - Pre War

1 Gauge Panel

1 Oil Pressure Gauge

1 Amp Gauge

1 Tachometer

Pre-War Windshield Brackets

Glass and Trim for gauges. We have not yet cast the new one.

This is our first attempt at reproducing your gauge panel

We have recieved these but are unsure of what they are.

Restoration Authorized

The boxes that are green is the current status of each part.

Tune up parts

1 Distributor Cap

1 Set of Contact points

1 Condenser

1 Rotor

1 Set of Spark Plugs

Note... this photo is an example. The one we found needs to be re-chromed

Upholstery Material - 4 yards

Tachometer Cable

Chrome- $200

Not Chrome- $150

Cylinder Head Gasket

(Are you wanting a complete set of gaskets or just the gasket for the cylinder head?)

If you do not have a fill tube and locking nut for your fuel tank you will need one.

2 Chris Craft Model "B" Engines

Chromed- $1121

Not Chromed- $399

We can't produce cheaper.

1/2 Down is for gauges only not trim or face plate.

$600 Total

$300 Paid

$300 Owed

Customer declined tune up parts.

We could not have a cable made with the correct fitting to attach to the tachometer. Simple solution we had an adapter made that will fit between the cable and tachometer.